How to open the car to save the oil experience to share _ life health

How to drive the most fuel-efficient
first, the new car running-in
The new car must be running-in within the first 3000 miles of mileage. New car running-in should pay attention to speed control within 80 kilometers per hour, as far as possible to reduce the rapid acceleration, rapid deceleration.
second, reasonable maintenance of automobiles--regular maintenance
Be aware that a car in good condition can save 15% to 20% oil.
1, air filter, petrol filter, oil filter: Each drive more than 5000 kilometers of accessories need to be replaced, because the air filter plug will cause a reduction in gas, resulting in inadequate gasoline combustion, reduce fuel efficiency, and gasoline filter congestion will make the engine work abnormally.
2, Oil: Add oil needs appropriate amount, pay attention to the scale of the oil scale marked. Too much oil will overwhelm the crankshaft, increase the resistance, too little oil can not play a lubrication and sealing effect, and even affect the efficiency of the engine.
3, Tire Status: Low tire pressure will lead to increased fuel consumption. According to the US Department of Energy, if the tyre pressure of each car is 1 pounds/square inches less than the standard pressure, the U.S. consumes 15 million litres of petrol a day, and periodically checks for uniform wear. If the tire is found to wear, or the steering wheel is not centered and so on abnormal situation, need to be repaired as soon as possible to the professional repair shop.
4, avoid decorative excessive, such as spoiler, rain cover, etc., will damage the design of the original car, improve fuel consumption; the trunk does not put a lot of things not commonly used, increase the deadweight load will increase fuel consumption, statistics show that each increase of 1 kilograms of the load will increase 1% fuel consumption; some drivers for fuel saving, It is not advisable to take a high-speed shutdown of air-conditioning and open the window ventilation, which is undesirable, when the speed of more than 85 kilometers per hour, the window after the wind resistance consumption than the air-conditioning system consumes more fuel, it will let your fuel economy index down 10%.
third, cultivate good driving habits
1, according to the different road conditions to choose a reasonable driving state: Reduce emergency acceleration and emergency turn. Not only to look at the previous car, but also to see the first two or three cars, to take measures in advance to reduce the brakes; do not refuel, a fierce plus and gently add to the same speed, fuel consumption can be up to 12 ml, at the same time driving, where possible, to maintain the most economic conditions: engine Speed 2000 to 3000 rpm, The speed is 60 to 90 kilometres per hour.
2, Shift time: Choose the best time to shift gear (engine speed is 2000 to 3000 RPM), to eliminate low speed, low speed drive often make fuel consumption over the normal value of 45%; the users of the hand-row car should avoid high gear.
3, reduce idling state: Moderate hot car is a good habit, it is recommended to let the car slow driving a distance to complete, a long time the original geothermal car will increase fuel consumption, long idle and idle running air conditioning in particular fuel consumption.

how to share the experience of saving oil by manual block

In the urban Open manual car, a lot of friends may have this feeling: the right hand is not idle, frequent start, shift, speed and deceleration. If the driver, of course, does not matter, but most drivers can not respond freely, resulting in higher fuel consumption, which should also be the experts, "the level of fuel consumption depends on driving technology."
We know that the throttle and the brakes are the two major factors in controlling the speed. If the two factors grasp well, save oil, also reduce the loss of vehicle parts, prolong the service life of the car. However, how to understand the throttle and brake on the speed control, how to operate to save oil, driving school for many years of car friends summed up a lot of drive skills, we can try.
Road Condition 1: Need to stop in front of 100 meters, the current gear is 3 block
Fuel saving: Rapid rise 4 block, and then with the Block glide
When you drive the car, first of all to clear the current situation, what kind of road conditions determine what kind of driving style: the front vision, the road other motor vehicles, non-motorized vehicles, pedestrians, road conditions and so on, depending on the road conditions, driving is different.
In front of 100 meters without obstacles in the case of parking, the current gear is 3, speed is 40 km/h, this is the end of this 100 meters, or the first throttle will speed in the shortest time mentioned 50 km/h, or even 60 km/h, and then rose 4 block?
The answer is the latter. But note that, after the 4 block to stop refueling, but in the 4 block with the skid, until 100 meters end. So, in a way, not all of the gas on the accelerator will be a grease. Of course, the accelerator of the moment is the oil, but this won the economic drive (do not step on the accelerator and glide) The time, then the economic driving speed and won back due to the instantaneous refueling and waste of oil, from the whole driving process, is still the province of oil.
Road Condition 2: When your distance from the front of the vehicle is not up to 3
Fuel Saving Ideas: Use 2 block refueling and change to an empty car
When you and the car in front of the distance, the speed is too late to rise to 3 block, but with 2 of the driving and seems too low, how to do?
"At this point you can let it in 2 block, and then a deep step on the accelerator, then do not rise into the 3 block, but cut into the air, the use of inertia slip car." Mr. Xu, a team driver with more than 20 years of age, summed up the experience. "This saves oil without having to put on the brakes because the speed is too fast after 3, and saves the trouble of switching from 3 to the next when approaching the vehicle." ”
Road Condition 3: A red light needs to start several times
Fuel saving: with 1 block refueling, hanging into the empty car
In the rush hour, through the intersection of the bustling road, often to meet a few red lights, also means that need to start several times, encountered this situation, how to drive will be compared to save oil?
According to experience, Mr. Chei Youjia said: "This relatively short distance, can use 1 to start not to hang into 2 gear, but in 1 block refueling slightly deeper after the homeopathy replaced by the air; in the car when the foot on the brakes can be at any time according to the distance between the vehicle and braking, or let the car in accordance with inertia to stop. ”
But what needs to be reminded is that the choice of "air slide" or "with skid" cannot be generalized. 3, 4 of course can be with the skid, but 1, 2 block in the actual operation is very difficult to take the skid, can only be empty block slippery.
Road Condition 4: Congested road, walk and stop
Fuel saving: Light on the accelerator and release, then step
Often in the vicinity of the intersection or the peak of the time, there is a walk and stop the situation, it can be tricky to deal with.
Braking is critical to speed control. Brakes can reduce the speed, but the way to slow down is not only a way to brake, throttle is also a way to control speed. Loosening the accelerator or not stepping on the accelerator is sometimes a better way to spin down than the brakes.
"One of the principles of driving is that you can use a loose throttle to slow down without braking," he said. "Taxi driver Liu said, according to the road ahead, to be predictable ahead of the throttle belt skid." In the need to brake the case, Liu Master suggested: the best to gently step on the first release, and then step. Although the brake will make the person sitting in the car feel a bit, but it is good for the vehicle, it avoids the brake pads due to wear and overheating caused by the problem, overheating after the braking effect is to be discounted.