Network bandwidth resources are limited. Some computers use a large amount of bandwidth for high-speed download and online videos, leading to slow internet access and network cards on other computers. TL-WDR5800 speed limit function can limit the maximum upper and lower speed of the computer, so as to ensure the reasonable use of the network bandwidth resources.
This paper introduces the application and setting method of TL-WDR5800's speed limit function.
The user's home broadband is 6 M (6000 Kbps). To ensure the normal use of intranet game computers, mobile phones, laptops, and other terminals, set the following restrictions:
Note:: This table is for reference only. The actual value shall prevail.
Log on to the vro management page and go
Common settingsClick
Connection Device Management, As shown in the following figure:
Click to modify the name of the connected computer (mobile phone), as shown in the following figure:
Change the desktop (game host) name
Game host, As shown in the following figure:
Set the host name as follows:
Note:After the name is changed, the vro connected to the client will automatically identify the set name.
Click the corresponding bandwidth value for the download speed limit and upstream speed limit of the host. As shown in the following figure:
Set the planned bandwidth limit. The list is as follows:
So far, the network speed limit takes effect. The maximum rate of the computer (mobile phone, notebook, etc.) connected to the router is the specified maximum value.
Note:After the client IP address changes, the speed limit still takes effect.
[1]
Can I set the minimum guaranteed bandwidth?
A: The maximum speed is the maximum speed limit for this vro, and the minimum guaranteed bandwidth cannot be set.
[2]
After the setting is complete, the effect is not obvious. What should I do?
A: When the configuration is complete and the bandwidth control effect is not obvious, you need to troubleshoot the following points:
(1) the set maximum control rate is reasonable, for example, the maximum 1000 K and K, there is no difference for opening the page.
(2) the setting value corresponds to the total bandwidth. If the total bandwidth is 2000Kb, the maximum value cannot exceed 2000Kb.
(3) confirm that the controlled host is the host you test, that is, the control terminal is correct, determined by IP address and MAC
