Huawei Router RIP configuration command

RIP configuration

The Rip [process-id] command is used to enable the RIP process. In this command, Process-id specifies the RIP process ID. If Process-id is not specified, the command uses 1  as the default process ID. VERSION&NBSP;2 enables RIPV2 to support extended capabilities, such as supporting VLSM, certification, and more. The network <network-address> command can be used to advertise a network in RIP     rip    version2     network 10.0.0.0rip metricin <metric value> is used to modify the measures applied on the interface. When a router's interface receives a route, the router first increments the additional measure of the interface to that route, and then joins the route to the routing table.     interface gigabitethernet 0/0/0    rip metricin The  2rip metricout <metric value>rip metricout is used by routers to modify the metrics of a route when it advertises RIP routes. With the Rip metricout command configured, only the measures configured in the command are applied. Horizontal Split & Poison reversal interface gigabitethernet 0/0/0rip split-horizone   horizontal split   enable RIP by default  poison-reverse   toxicity Reversal Verification Configuration display rip <process_id> interface < interface> verbose        display rip 1  interface gigabitethernet0/0/0 verbose        poison-reverse:enabled     split-horizon :enabled         both show "Enabled", only "Poison-reverse" Effect. Disable/enable RIP send RIP message     interface gigabitethernet 0/0/0    undo  rip output     #  prohibit sending of sending messages     rip output           #  start send Send message prohibit/enable RIP receive RIP message      interface gigabitethernet 0/0/0    undo rip input      #  prohibit interface sending messages     rip input           #  Start interface Send message suppression port          only receive not send RIP messages      rip    silent-interface gigabitethernet 0/0/1      Verifying configuration     d isplay rip         can compare the RIP information of a comprehensive real-world router 

This article is from the "Sleep Blog" blog, please be sure to keep this source http://wujue.blog.51cto.com/11999347/1882457

Huawei Router RIP configuration command