1. Restart the service. As prompted,Press F1 to enter the configuration.
Configuration interface:
F1: configuration, Master configuration, and important configuration.
F2: diagnosis, no management required.
F12: Set the boot device, that is, the local hard disk is started, USB device driver.
2. If you press F2, the following interface is displayed, and the system is stuck.
3. Set CPU virtualization and Process
4. Local hard disk raid group. The following shows that the raid group is successfully created. If raid is not performed, information such as raid0, raid1, RAID5, raid10, and raid01 will be displayed. Here, I have created raid groups for countless times,No full configure is displayed at the bottom of the raid configuration item.Operation, there is a save prompt here (it has not been found to save, it took a lot of time).
After the hard disk is ready, install esxi5.5 to find the hard disk.
5. esxi5.5: copy the image again and make a USB flash drive image. An error is reported during installation.
Download the image VMware-VMvisor-Installer-5.5.0.update02-2068190.x86_64.iso again"To solve the problem.
6. Install esxi5.5 on IBM and set system hardware parameters.
Does CPU support virtualization?, You can query Reference Links: https://ark.intel.com/zh-CN/products/75288/Intel-Xeon-Processor-E5-4640-v2-20M-Cache-2_20-GHz
The installation is complete. There are many pitfalls here. You can refer to them as a system administrator.
Install esxi5.5 on IBM x3750 M4