Install the xp sata driver on the 945 and 965 platforms

Xp sata drive: http://download.boulder.ibm.com/ibmdl/pub/pc/pccbbs/mobiles/7kim06ww.exe

Step 1: List several models (other models)
A) IBM, of course, is boot, F1, into the bios, enter the bios, the first CONFIG-SERIAL ATA (SATA) Press enter, put the original

Changed the ahci mode to compatibility mode, F10, confirm to exit, start the CD, install XP, there is no suspense until XP

After installation is complete, enter an empty system with incomplete drivers.

B) the hard disk cannot be found when Dell installs Windows XP.
Cause
The new notebook contains the Robson module, which supports Vista but does not support XP.
Solution
Press f2 to enter the bios, and change "Flash cache MOD" from "enabled" to "off" under "onboard devices ".

"; Then" SATA operation "is changed from" ahci "to" ata"

C) HP columns such as tc4400
Solution
Press F10 to enter the BIOS after the device is started, and "SATA" is included in "device configurations" under "System Configuration ".

Native mode is changed from "enabled" to "Disable"; then F10, confirm to exit, start the CD, install XP (TPC)

D) Fujitsu example: t2010

Set bios, press F12 at startup, and choose the menu to go:
BIOS---ADVANCED---INTERNAL device CONFIGURATIONS---SATA controller change enabled (active) to disabled (disabled)

Some different models or BIOS versions change the ahci mode to disabled (disabled) and satacontroller to enabled (activated)

Go to boot ---> boot device priority, HDD below, pull it with Space key, set 1 to CD, 2 to HDD

Press the F10 key to save the settings and restart and boot the computer to install the system with the drive that loads the XP Tablet system disk. after installing the system, follow these steps. If you are prompted to restart the computer and restart the system immediately, do not hesitate:

Step 2: Install the SATA driver so that you can better take advantage of the SATA hard drive.

Installation Method:
Run after download, will decompress to C:-DRIVERS-WIN-IMSM
Then there is an install under the prepare directory under the imsm directory. CMD Installation File, run it
After the restart, go to the bios, change the SATA hard disk mode back to Achi again, press F10 to save and exit the bios, enter the system, and find new hardware,

Find the driver, directory pointing to C:-DRIVERS-WIN-IMSM, so install the SATA driver