left mouse button Click to double-click the solution _ Application Tips

I have a problem with the Logitech Mouse, it seems to be the problem of micro-switch, from the Internet to find some information, have time to try.
Quote:
Open the mouse, find the left mouse button micro-switch, a small black box card on the circuit board. Open the micro-switch method is to use toothpicks from the side of the small hole inserted pry open, tap micro-switch in the middle of the clamp, pay attention to not blindly inserted, observe the above organs again, be careful not to force too hard to cause plastic cover damage. Gently switch on the top of the lid open, then you can see the following copper, copper if the variant is taken down to carefully back to the original shape, and then put back.

With cotton sticks dipped in alcohol to clean the copper pieces, cleaning process, the force should be even, to avoid the displacement of copper pieces. Be sure not to bring water, wipe the time not too hard, or it will cause a short mouse.

After cleaning, if the problem has not been resolved, the reason is likely to be the contact point appears burr, this time need to fine sandpaper will be the contact point under the Copper sheet grinding (mainly the burr part to clear off on the line), and then use alcohol to clean. If you can not find fine sandpaper and alcohol, with a small screwdriver into the copper plate in a lot of friction contact point will also be able to emergency.

Finally fitted back to the original appearance on it, attention to assembly reduction micro-switch, "Click Small plastic Block" to be installed according to the original position.