Make water reflection with PS

Teach you to use PS to make water reflection on the scene, you can turn a mountain into a small island. Of course, you can also use the relevant knowledge mentioned in the other place p into the underwater world, such as their own home.

First, you need to find a picture that looks good for your reflection, such as the Saint Michel, Mt. in Paris (Mont Saint Michel).

Copy the original layer, then pull to the bottom, edit –> transform –> vertical Flip, make the new layer into a reflection

Add a layer to fill the water blue (ie background color)

Add a mask (layer mask) to the reflection map, and then build a gradient layer

Click the reflection map, then go to the filter –> blur –> dynamic blur, Angle set 90, spacing 10 pixels

This is the time to start a new PSD file, adjust to the appropriate size

Filter > Noise –> increase noise.

The total is set to the highest

Filter –> fuzzy –> Gaussian Blur

The strength is set to 2 pixels.

Select the color version channels (see figure right) Red, then filter –> (stylise) –> embossed (emboss)

The angle is set to 180, the height is 1 pixels, the total is set to the highest

Green version repeats once, but this time angle is 90

Back to the layer and right click on the background layer

Edit –> Transform –> Perspective (Perspective)

We can adjust the bottom part by widening the width.

Image –> image dimensions. Pay attention to the lower left corner do not tick "force equal proportion", the pattern pressed into a square

You'll get a graphic like this.

Back to the original image, select the reflection. Then go to the filter –> Twist –> Move (displace)

The wave effect is probably complete, and the following is the photo post modification and tonal processing.

Add a layer, then select a cross between the top and bottom of the two graphs, then fill the black.

Deselect, then go to filter –> blur –> Gaussian blur with a strength of 20 pixels

Set the layer to soft light and the opacity set to 80, as shown below

Add an adjustment layer "hue/saturation" (hue/saturation adjustment layer), and then reduce the saturation by 2

Add another adjustment layer "black and white", and then select the preset "Green filter", see the following figure left, remember the blending mode to use "overlay"

Add another adjustment layer "gradient layer" (gradient), set the following figure, the style is radioactive, angle 90, zoom 150

When the time is done

Category:

• PS Image Processing