CTRL + AUTO Extension Cable//or press M to appear move&drag menu
Select device, shift+ left mouse button = Copy =ctrl+d (direct out device)
When the bus is multi-rooted. Bus databus[0..7]+ separate Databus0
Pay attention to the role of Knowledge Center.
For changing the whole "U." "Similar components: tools-annotates sch-updata Changes List
When editing a check: Double-click the device to check the hidden pin (show below).
"Place" palce-direc-no ERC, no electrical rule checks, elimination of compilation warnings
When editing, Palce-direc-compile mask to compile the mask
Place-parameter set advance constraint line wide Ah, through the hole AH
PCB rule
Paste: Below system inside Clipboard. Select schematic, press CTRL + C, copy succeeded
Paste has a smart paster intelligent paste, you can choose to paste content
For component lookup: Edit-find text (current--all--(designators only (smaller search), all));
Find and replace lookup is also very convenient;
SCH Inspector complete component modifications for easy viewing
SCH Sheet Global Inspection.
Global edit (or modify): Capacitive inline-table sticker modification: Edit can be changed individually 0805
"1" Global "e+n": 1. Edit-find similar-cross cursor;
2 Direct right-click; for cap and current footprint change to same;
Observe Sch Inspector, where the current footprint is changed to 6-0805.
When all is selected, "2" and then right-click Find similar, the top selected select Same
Observe Sch Inspector, where the current footprint is changed to 6-0805.
"3" Global "E+n": 1. Edit-find similar-Cross cursor, 2 directly right button, select Description to same, and then
Edit-select-all to circle all the capacitors
When you're done, click Clear in the lower right corner.
Note:: Find Similar the following select Matching
Footprint Manager observes all packages for easy viewing and change.
"Component Library"
Automatic increase/decrease of marking, Tools-sch preference-schematic-gneeral (reduced to-1)
VCC and GND can be hidden, want to see in view-show hidden;
You can add links to the schematic diagram, in the edit value inside the link is the line.
Under construction, tools-new component.
For things in the library can be arbitrarily dragged, select Component Properties under the Lockpin not tick
"Hidden pin" Double-click the original, click on the lower left corner pin, which can be set