Photoshop adds a soft classical yellow-green to the forest wedding slice

Introduction to the classic yellow-green picture palette method. General process: can be based on the color composition of the picture, quickly use the color palette to turn the main color to yellow-green, and then in the high light part of the increase of light yellow, dark part and then add some dark blue and so on.

Original

< small map view big picture >

Final effect

< small map view big picture >

1, open the original material, create an optional color adjustment layer, green, green, blue, white, black to adjust, parameter settings such as Figure 1-5, the effect is shown in Figure 6. This step turns the main color green of the material into yellow-green and increases the dark blue.

< map 1>

< map 2>

< map 3>

< map 4>

< map 5>

< map 6>

2, create curve adjustment layer, the blue adjustment, parameter settings such as Figure 7, the effect is shown in Figure 8. This step increases the picture's yellow with blue.

< map 7>

< map 8>

3, create color balance adjustment layer, to adjust the high light, parameter settings such as Figure 9, the effect is shown in Figure 10. This step increases the high light part of the warm color.

< map 9>

< map 10>

4, create optional color adjustment layer, yellow, black adjustment, parameter settings such as Figure 11,12, the effect is shown in Figure 13. This step is to fine-tune the color of the leaves and dark parts.

< map 11>

< map 12>

< map 13>

5, press CTRL + J to copy the current optional color adjustment layer, the opacity to: 60%, the effect of the following figure.

< map 14>

6, press CTRL + ALT + ~ Pull out the high light selection, create a new layer filled with light yellow: #FBDA82, the opacity to: 10%, the effect of the following figure.

< map 15>

7, create a color balance adjustment layer, the high light adjustment, parameter settings such as Figure 16, after the layer to determine the opacity to: 60%, the effect of Figure 17. This step increases the yellow portion of the high light.

< map 16>

< map 17>

8, create curve adjustment layer, the RGB, blue for fine-tuning, parameter settings such as Figure 18, to determine the layer opacity to: 30%, the effect is as Figure 19.

< map 18>

< map 19>

9, create a new layer, press CTRL + ALT + Shift + E-stamped layer. Simple to the character of the skin, and then use the Lasso tool to select the face, appropriate feather after the appropriate brightness, the approximate effect of the following figure.

< map 20>

10, a new layer, fill light yellow: #FBDA82, blending mode to "filter", add layer mask, with a black brush to the upper right corner of the section, the effect of the following figure.

< map 21>

11, create an optional color adjustment layer, the white adjustment, parameter settings such as Figure 22, to determine the layer opacity to: 50%, the effect is as Figure 23.

< map 22>

< map 23>

12, a new layer, stamped layer. Simple to the bottom of the picture with a dark angle, and then properly soften the whole, the general effect of the following figure.

< map 24>

13, press CTRL + ALT + ~ Up the high light selection, create a new layer fill light yellow: #FBDA82, the opacity to: 15%, the effect of the following figure.

< map 25>

Finally adjust the overall color, complete the final effect.

< small map view big picture >

Category:

• PS Palette Tutorial