Remove a router VPN fault in a moment

It takes many attempts to eliminate the router VPN fault in a moment. The following is a reply from a netizen. I hope you can give it a try. It is a common method to help fans. Take the opportunity to provide it to you.

◆ Router VPN troubleshooting: VPN is a secure connection between two networks over the Internet, for example, connecting a home network and an office network. It requires both networks to have special devices or software.

◆ Router VPN troubleshooting: the router's VPN penetration function does not mean that it is competent to establish a VPN, but that it can run the VPN tunnel created by other devices.

◆ Router VPN troubleshooting: All NETGEAR routers support IPSec, PPTP, and L2TP VPN penetration. By default, no vro settings need to be modified.

◆ Router VPN troubleshooting: if the original VPN cannot be used after the NETGEAR vrogear is installed, refer to the following content:

◆ Router VPN troubleshooting: If your VPN device supports NAT-T (NAT penetration), but the lack of time is not enabled, Please enable this function.

◆ Vrovpn VPN troubleshooting: contact your network administrator to help you complete VPN configuration (Common VPN Client software includes CiscoNAT-T or NETGEARProSafe.

◆ Router VPN troubleshooting: If your company uses L2TP penetration, you have registered your computer's MAC address to the company's system administrator. Find the MAC address of the router on the back of the router) and register it.

◆ Router VPN troubleshooting: Upgrade the router firmware. Open Port ing. The IPsecVPN ports are 50, 51, and 500, the PPTPVPN ports are 1723, And the L2TP ports are 1701.

◆ Router VPN troubleshooting: by default, the firewall function of the NETGEAR router discards ICMP packets from the Internet received by the WAN port, and your VPN application may use ICMP packets, therefore, you can log on to the vro Management page and select WANSetup in the left-side function list. Check the value before RespondtopingonInternetPort.