Resolution of the network card cannot be started after VMware cloning CentOS

Comment out the original eth0 line, and then change the generated eth1 to eth0 (you can add this file if you don't have the file)

[Email protected] ~]# Cat/etc/udev/rules.d/70-persistent-net.rules
# This file is automatically generated by the/lib/udev/write_net_rules
# program, run by the Persistent-net-generator.rules rules file.
#
# can modify it, as long as you keep each rule to a single
# line, and change is only the value of the Name= key.

# PCI Device 0x8086:0x100f (e1000)
#SUBSYSTEM = = "NET", action== "Add", drivers== "? *", attr{address}== "00:0c:29:8c:61:3e", attr{type}== "1", kernel== "eth* ", name=" eth0 "

# PCI Device 0x8086:0x100f (e1000)
subsystem== "NET", action== "Add", drivers== "? *", attr{address}== "00:0c:29:3c:e6:09", attr{type}== "1", kernel== "eth*" , name= "Eth0"
[Email protected] ~]#

Finally modify the network card configuration file

[Email protected] ~]# Cat/etc/sysconfig/network-scripts/ifcfg-eth0
Device=eth0
Type=ethernet
uuid=fb802c67-087a-4f50-812b-f3d20053aa4b
Onboot=yes
Nm_controlled=yes
Bootproto=none
hwaddr=00:0c:29:3c:e6:09
ipaddr=192.168.100.212
Prefix=24
gateway=192.168.100.1
dns1=192.168.100.1
Defroute=yes
Ipv4_failure_fatal=yes
Ipv6init=no
Name= "System eth0"
[Email protected] ~]#

Finally reboot the system

This article is from the "Sim blog," Please make sure to keep this source http://mitac.blog.51cto.com/1081911/1629060

Resolution of the network card cannot be started after VMware cloning CentOS