Setting up soft AP under Win7--method two

Command Prompt ( CMD ) to establish the soft AP

Steps / method (driver installation and user access are established under the interface AP is the same)

1. Click Start - Run, input cmd, enter.

2. Enter in cmd :netsh wlan showdrivers enter . To see if the wireless network card supports hosting the network: Yes, then next if no, the virtual AP cannot be turned on

3. continue input : netsh wlan set hostednetwork mode=allow Ssid=wifi key=12345678

4. You have successfully established a virtual ap, and then enter the command: netsh wlan start hostednetwork, open our software APs

at this point, the enabled virtual AP , other notebooks or mobile phones to search for this wireless AP Connect, enter a password 12345678 can be connected. Finally, the Internet connection in the local settings to share the properties of the virtual AP can be. In this way, we can share the Internet with multiple notebooks via win7 virtual APs .

5. Turn off the wireless AP

6. Disable wireless APS

Setting up soft AP under Win7--method two