Some common problems and solutions in Win7 system

In the use of computers will inevitably encounter some small problems, and small problems if you know the solution, then basically a few minutes can be solved, and if you do not know can be a long time or Baidu for a long time to find a solution.

1

Screenshot Flower Screen

This problem is mainly because the graphics driver and your graphics card is not very good with the situation will occur, we only need to change the graphics driver is basically no problem.

2

Disorder of the disk character

The drive-by-letter disorder has often occurred since the Win95 era, and this time Windows 7 is more severe. If you are installing Windows 7 from a CD, the system will set its partition to C, and then arrange other partitions according to management. It is not easy to troubleshoot the disk break in Windows 7, and you need to manually set the letter in Disk Management before you upgrade the system again. The specific steps are as follows:

1, into the "control Panel → management tools → Computer Management → Disk Management", and then the confusion of the disk character set for you want to look.

2, restart Windows 7, at this point you will receive a lot of error prompts, and can not get into the desktop. Press the "Win+r" key combination to start the "Run" box, and then click "Browse" to locate the Setup.exe under your Windows 7 installation CD, and click OK to start the Windows 7 installer.

3, when the installation program to choose your upgrade or a new installation, be sure to choose a new installation, so that after the installed, Windows 7 will not change your letter. The old Windows 7 is automatically backed up by the installer into a windows.old directory, although you can delete it

3

Retrieve the Disappearing Run dialog box

By default, the bottom of the Windows 7 Start menu is not the familiar "run" command, which can cause inconvenience to some higher-level operations. We can use the following two ways to bring up the "Run" dialog box.

1, through the "win+r" key combination, you can open the "Run" dialog box, this trick we have used in the fourth question.

2. Right-click on the Start menu, select "Properties", go to the Start Menu property settings interface, click the "Customize" button at the bottom, find "show run" in the list box below and check, then click "OK" to exit, and then you can find the "run" command again from the bottom of the Start menu.

The above is about Win7 system common some small problems and solutions, hope to be able to help you.

Note : More wonderful tutorials Please pay attention to the triple computer tutorial section, triple Computer office group: 189034526 welcome you to join