Steps for configuring the bridge and virtual server of the Belkin Router

Networks have been widely used in our lives, and wireless bridging and Intranet Server SETUP are often used in Wireless LAN. Today, I will take the Belkin wireless router as an example to describe the configuration steps.
1. Wireless bridging (1) log on to the Belkin wireless router and click wireless bridging in the left-side navigation bar. The Management page on the right shows the three requirements to be met, set according to your own situation. (2) When three conditions are met, You must select the enable wireless bridging option below and set the online AP, which can be found in AP1, 2, 3, 4. Enter the MAC address of the corresponding AP. If you want to disable the online wireless client, select the lower option and click Save. Then you can use the wireless bridging function. Www.2cto.com

(3) If you want to use the Belkin wireless router as the base station, you must also enable the base station function. Then, specify an IP address and subnet mask for it.

2. If a Web server or FTP server needs to be created for a virtual server, this function is first added to the virtual server project under the firewall bar, select the type of the server to be set up, enter the description in the parameter box below, enter the connection port and type, and then enable the setting in the preceding check box, then, set the IP address of the computer on which the Intranet is to be used as the server, and fill in the following IP address and connection port parameter boxes.

The bridging and virtual server functions of the Belkin wireless router have been introduced. If you need them, you can follow the instructions. This article is from