Note:Devices in the TP-LINK new territories can only disable connection signals from specific terminals.
Requirements in this example: The wireless network in the home is afraid of network access. If you want to set up to allow wireless connections only to mobile phones and laptops in the home, access to other terminals is prohibited.
|
Terminal
|
MAC
Address
|
|
Mobile phone
|
00-21-27-B7-7E-15
|
|
Notebook
|
00-0A-EB-00-07-5F
|
The above is only an example of this article. Please refer to the actual parameters.
Make sure to confirm the MAC address of the terminal before setting it. (how can I confirm the MAC address ?)
Log on to the vro management page and click
Wireless Settings>
Wireless
MAC
Address Filtering, Filtering rule selection
Allow, As follows:
Click
Add new entry, Enter the MAC allowed entries of the mobile phone, as follows:
Similarly, add the MAC address entry of the notebook. The list is as follows:
Click
Enable filtering, Make sure that the MAC address filtering function is:
Enabled, As follows:
Now, the wireless MAC address filtering is complete.
If your wireless router interface is a new interface, as shown in the following figure:
A specific network device can be prohibited from accessing wireless signals. The method is as follows:
1. Click
Device Management:
2. Click
Master network(Or
Visitor device), Find the device that is not connected, and click
Disable.
