The system fault caused by serial port hard disk data line and its solution

The first generation of serial hard data cable is often fixed, easy to loose, resulting in unexpected system failures, the author has encountered this situation, the following one to explore solutions.

Steps/Methods

Serial hard disk has such advantages and the development of a huge potential, so gradually replaced by the mouth of the hard disk, but began to produce the data line of the serial hard disk is very easy to loose, often pulled plug several times, basically difficult to plug in, loose often caused some problems. If you are a computer master, it is easy to distinguish, but often so annoying, if you know very little about computer knowledge, it will be confused.

When the serial port hard data cable is loose, the hard drive light is still bright, the system becomes extremely shou slow, each carries on one step operation, very long only then reacts, lets the human unbearable. At this time there is no choice but to shut down, of course, not by power off, although the data line is loose, hard drive or to protect, still from the "Start" menu shutdown. Shutdown may also be used for 5--10 minutes, depending on the specific circumstances; In order to avoid causing other abnormalities, do not press the power supply directly because of the urgency. Power off after the shutdown, the data line plugged in, if the data line is too loose, the proposal to buy another, of course, to buy a joint with iron buckle, there will be no loose iron buckle fixed.

The author bought A, loose problem thoroughly solved, but the first time to access the folder or file with the right to slow down a little. The problem is always this, there is always such a shortage.