Use sconfig. CMD to configure servercore

In servercore, the following management tools are available:

Volume, scregedit. WSF

In Windows Server 2012 R2, you can use the server configuration tool (sconfig. cmd) to configure and manage several common aspects of server core installation.

You must be a member of the Administrator group to use this tool.

Sconfig. CMD is available on the minimal server interface and in "fully installed" mode.

Open the server configuration tool:

Type sconfig. CMD under cmd. Open the server configuration tool interface,

650) This. width = 650; "Title =" 1.jpg" alt = "wkiom1or4xxz9_o2aai0tr9thlg067.jpg" src = "http://s3.51cto.com/wyfs02/M01/36/F8/wKiom1Or4XXz9_O2AAI0Tr9thLg067.jpg"/>

This method is simpler than the following method in earlier versions of 08 or 08r2. In cmd:

Computer Name: Hostname

Change the computer name: netdom renamecomputer (oldcomputername)/newname :( newcomputername)

650) This. width = 650; "Title =" 2.jpg" src = "http://s3.51cto.com/wyfs02/M00/37/21/wKioL1OsKL2QnHyYAADG-D-JXnw484.jpg" alt = "wKioL1OsKL2QnHyYAADG-D-JXnw484.jpg"/>

Modify IP: netsh interface IPv4 show Interface

Netsh interface IPv4 set address name = "idx" Source = static address = IP mask = mask gateway = Gateway

Add DNS: netsh interface IPv4 add dnsserver name = "idx address = IP Index = 1

650) This. width = 650; "Title =" 3.jpg" src = "http://s3.51cto.com/wyfs02/M00/37/22/wKiom1OsK7zA9FdkAAF3oSfmWe0794.jpg" alt = "wkiom1osk7za9fdkaaf3osfmwe0794.jpg"/>

Modify the firewall, shut down or restart the firewall.

650) This. width = 650; "Title =" 4.jpg" src = "http://s3.51cto.com/wyfs02/M02/37/22/wKiom1OsLBryWjWCAAEGy_nqJs8927.jpg" alt = "wkiom1oslbrywjwcaaegy_nqjs8927.jpg"/>

You can also test whether to use servercore to install adds as DC and use dcpromo/unattend as the self-response file.

The sconfig. CMD Tool is quite practical.

This article is from "1 + 1 = ?" Blog. For more information, contact the author!