What if the broadband router WAN port fails to connect?

Internet bar Broadband Router WAN port is not connected, the router WAN port status has been shown in the connection. In the event of such a situation, consideration may be given to the following:

1. Check the network physical wiring is properly connected, the relevant equipment is normally open and use.

2. Confirm that the broadband account password input is correct, you can not pick up the router single dial. Try or enter the router management interface to click System Tools----System log. If the following log shows the broadband account password error:

3. If the network cable access broadband, you can try to change the WAN port rate, such as 10M Full-duplex, since the drive to improve the router.

4. Router WAN port is not connected, it is possible that the operator is bound to the computer's MAC address and detected by the router's MAC address, so you can try to clone the MAC address.

5. You can try to upgrade the software version of the router, and then restore the factory settings and reconfigure.

If none of the above methods can be solved, the customer will be able to do the comparative test. Take the router to other environmental tests to see if it works properly, make sure that the router's hardware itself is not a problem, or ask the customer if the router is working properly with other brands to determine if the environment is not functioning properly.

The following is the detailed setup steps of the Internet bar broadband router Wan port.

1, change the router WAN port rate

Login Router's management interface (192.168.0.1), and then expand the "Advanced settings" → "wan port parameter Settings" in the page on the right to select the corresponding rate mode (generally to 10M Full-duplex) point to save it, the following figure:

2. Clone Router MAC address

Login Router's admin interface 192.168.0.1→ Advanced Settings →mac address clone----Click Clone MAC address, last click Save.

The above is the router WAN port display has been connected to the reason analysis and the solution, the network management only need to follow the above procedure to solve the problem quickly.