avid isis

Ting enableR2 (config-if) #int fa0/0R2 (config-if) #ipv6 RIP Ting enablerouting configuration for R3:R3 (config-if) #int fa1/0R3 (config-if) #ipv6 RIPR3 (config-if) #ipv6 rip Hai enR3 (config-if) #int fa0/0R3 (config-if) #ipv6 rip Hai enR3 (config-if) #int Loo 0R3 (config-if) #ipv6 rip Hai enGrasping packet analysis between R1 and R3;650) this.width=650; "src=" http://s3.51cto.com/wyfs02/M02/58/D4/wKiom1S90OLhFaa-AALC0r9NhjU193.jpg "title=" 1.png " alt= "Wkiom1s90olhfaa-aalc0r9nhju193.jpg"/>gra

Technorati Tags: ccie,isp, operator, Isis,is-is1, area, AreaThe OSPF area----0, the backbone area. 1, non-backbone area.In Isis, the area is no longer determined by number.--isis allows the entire routing domain to be divided into multiple zones.-- A router currently has a maximum of 254 area IDs. Configure different zone IDs for smooth zone merging, segmentatio

Huawei's configuration: As shown in the following illustration, for the purpose of understanding the IP address (C class address/30 mask) that is used to make the host name connected between them. The blue area is Area1, the green area is Area2, and they are in ISIS's agreement. R7 and R8 are also doing ISIS, but not to R3 and R6 (R3 and R7, R6 and R8 to run EBGP between them) The following command: 0 0 means never time out, no matter when the in

Tunnel0No ip addressNo ip redirectsIpv6 address 2002: C0A8: 101: 13: 1/64Tunnel source Ethernet0Tunnel mode ipv6ip 6to4Interface Ethernet0Ip address 192.168.1.1 255.255.255.0Ipv6 route 2002:/16 Tunnel0 R1 # sh ipv6 int briefEthernet0 [up/up]UnassignedLoopback0 [up/up]FE80: 210: 7BFF: fe36: 4912002: C0A8: 101: 1: 1Tunnel0 [up/up]FE80: C0A8: 1012002: C0A8: 101: 13: 1Virtual-Access1 [up/up]Unassigned R1 # sh ipv6 routeIPv6 Routing Table-8 entriesCodes: C-Connected, L-Local, S-Static, R- RIP, B-BGP

support new computer network protocols. The new features simplify network devices and operations, and the upgrade will not be so troublesome when OSPFv3 is used. (2) The difference between IS-ISv6 and IS-ISv4 Another connection status Protocol widely used by carriers is isforipv6. We know that isis is a standard routing protocol (ISO/IEC10589) that was originally used to support dynamic protocols of CLNS networks. Because the design of

metric 10000 100 255 1 1500 re-distributing RIP without the AS or process number, when the time is re-allocated to IGRP and ospf, the bandwidth is: bandwidth delay reliability loading mturouter (config) # router ospf 2 router (config-Router) # redistribute isis level-2 subnets resdistributing ISIS only L2 routes. When it is sent to OSPF, use the SUBNETS parameter to redistribute subnets in the classificati

classless!!Line con 0Line aux 0Line vty 0 4Login!End　　　　R2Version 11.2:No service password-encryptionNo service udp-small-serversNo service tcp-small-servers!Hostname R2!Boot system flash slot0: c3620-js-mz_112-20_P.bin!Ip host R1 2001 152.1.1.2Ip host R3 2003 152.1.1.2Ip host R4 2004 152.1.1.2Ip host R5 2005 152.1.1.2Ip host cat 2008 152.1.1.2!Clns routing!Interface Loopback0Ip address 152.1.1.2 255.255.255.255.255!Interface Ethernet0/0Ip address 152.1.1.130 255.255.255.255.128Ip router isisIs

-performance and scalable Image Recognition solutions. The leadtools Asian OCR module can be seamlessly used with document and medical technologies in leadtools sdks. Imagegear for. Net v1_4 Abstract: This feature allows you to add scanning and compression, OCR and bar code recognition, PDF and vector graph support, File Viewing, processing and printing, and graphic editing and processing functions to your application. Imagekit7 v7.0 Abstract: imagekit7 is a control product based on Activex

Cornell's K. Birman (the originator of virtual synchronization)History of Virtual Synchrony ReplicationThis article describes the development history of Virtual Synchrony. Based on this article, the core documents of Virtual synchronization are sorted out as follows: • J.M. Chang, N.F. Maxemchuck, "Reliable broadcast protocols", ACM Trans. on. Computer Systems 2 (3), Aug. 1984, pp. 251-273• F. cristian, H. aghali, R. strong and D. dolev, "Atomic Broadcast: From Simple Message Diffusion to Byzant

There are many network protocols, such as isis, rip, ospf, and bgp. In large companies, network devices often run multiple network protocols, if no configuration is required between various network protocols, no information can be exchanged between devices. In this case, the routing redistribution technology appears, the purpose of Route redistribution is to achieve collaboration among multiple routing protocols. Routing redistribution principle: by a

address 2009:1212::1 is a multicast addressMTU is bytesICMP error Messages limited to one every millisecondsICMP redirects is enabled//enable ICMP redirectionND Dad is enabled, number of dad attempts:1//nd (neighbor detection) and duplicate address detection startND reachable time is 30000 millisecondsND advertised reachable time is 0 milliseconds//(neighbor detection) up toND advertised retransmit interval is 0 millisecondsND Router Advertisements is sent every secondsND Router advertisements

Many years ago, the US military wanted to give a name to a computer language, and many of them were not very fond of it. Someone suggested that the computer language should be named as follows: ada. No one raised an objection. Why do we all agree to use this name? This has to start more than 100 years ago.Ada is an imaginary girl.December 10, 1815, UK. A girl was born, her mother, a woman with an outstanding mathematical talent, called the "parallelogram Princess", and her father, an

Many years ago, the US military wanted to give a name to a computer language, and many of them were not very fond of it. Someone suggested that the computer language should be named as follows: ada. No one raised an objection. Why do we all agree to use this name? This has to start more than 100 years ago. Ada is an imaginary girl. December 10, 1815, UK. A girl was born, her mother, a woman with an outstanding mathematical talent, called the "parallelogram Princess", and her father, an

An overview of the Three Kingdoms written by Americans An overview of the Three Kingdoms written by Americans Note: This is a long post I have seen on a foreign Three Kingdoms unparalleled game Forum. The author is novosquare, the stupid. He is an avid player in the Three Kingdoms industry. He has done some research on everyone in the Three Kingdoms, and it is not easy to be a foreigner ...... Also very idle ...... I just finished my paper

changes to a pop-up menu. From this menu, the user can select the channels to include in the export. Control surface Support Premiere Pro now allows users to interactively mix audio with common control surfaces using the EUCON and Mackie protocols. You can also use a third-party tablet controller that supports these protocols. To connect the user's controller to Premiere Pro, choose Edit > Preferences > Control surface. Select the Controller protocol from the device class menu. Use the atte

Is-is neighbors cannot establish the following troubleshooting: Network environment The Is-is routing protocol is run between two NE80, and a Ip-trunk interface is connected through the transmission via 3 2.5G POS interface. Ip-trunk link status is up, two NE80 devices can ping each other, but cannot establish is-is neighbor relationship. Fault analysis There may be several reasons for this Is-is configuration is inconsistent on step 12 devices. Step 22 device versions are inco

and ISIS two kinds of IGP protocols, and OSPF should be much wider than ISIS, the students who understand OSPF and the number of OSPF are far greater than ISIS, so it is more necessary to have a good review Spf--shorest path Tree's path selection principle. Here again to review the SPF algorithm, understanding of SPF, CSPF is based on SPF evolved. It is also a

IS-IS Basic ConceptsTechnorati label: CCIS, ISP, IS-IS, IS first. ISIS --- Intermediate System-Intermediate system ---- Intermediate system terminology: IS: Intermediate System Intermediate system (Router) DIS: Designated Intermediate system specify Intermediate system (Designated Router) ES: end system (Host) SysID: System ID (Router ID) PDU: Packet data unit packet data unit (IP Packet) LSP: link State Protocol Data unit Link State Data unit (ospf l

(config-if) # ip add 3.3.3.3 255.255.255.255 P (config-if) # no sh R4PE2 (config) # int f0/0PE2 (config-if) # ip add 100.1.1.6 255.255.255.252PE2 (config-if) # no shPE2 (config) # int F0/1PE2 (config-if) # ip add 192.168.2.1 255.255.255.0PE2 (config-if) # no shPE2 (config) # int lo0PE2 (config-if) # ip add 4.4.4.4 255.255.255.255 R5: CE2 (config) # int s0/1CE2 (config-if) # ip add 192.168.2.2 255.255.255.0CE2 (config-if) # no shCE2 (config) # int lo0CE2 (config-if) # ip add 5.5.5.5 255.255.255.

192.168.2.1 255.255.255.0R2 (config-if) # no shuR2 (config-if) # exitR2 (config) # router isisR2 (config-router) # net 49.0001.2222.2222.2222.00R2 (config-router) # is-type level-1R2 (config-router) # exitR2 (config) # router isis BR2 (config-router) # net 49.0002.2222.2222.2222.00R2 (config-router) # is-type level-1-2R2 (config-router) # exitR2 (config) # int f0/0R2 (config-if) # ip router isisR2 (config-if) # exitR2 (config) # int f1/0R2 (config-if