industrial router table

Product Overview:GPRS General Packet RadioService (GPRS) is a universal grouping wireless service. It is a mobile data service available to GSM mobile phone users. It is often described as "2.5 GB ". The theoretical speed can reach 171.2 kbps. Currently, China Mobile Communication Corporation is widely used in GPRS networks in China. The InRouter 300 series combines Ethernet development requirements and uses the 2.5G/3G mobile network as the bearer network for remote wireless data transmission,

OSPF neighbor Table query on the R1 Router R1 # sh ip ospf neighbor command for querying OSPF neighbor table Neighbor ID Pri State Dead Time Address Interface 2.2.2.2 1 FULL/-00:00:35 199.99.1.2 Serial1/0 "Neighbor ID" indicates the route ID of the neighboring router, and the route ID is the unique ide

RIP routers are widely used and are believed to have been used by most administrators. How can we analyze the route table content of the RIP Router? The following describes the route table of the RIP Router. The fact that RIP records only one route for each destination requires that RIP actively maintain the integrity

Standard route table 1. The basic idea of road selection at the next stop The route table only specifies the next step from the router to the destination path, without knowing the complete path to the destination. 2. The standard IP route table contains many (N, R) pairs. N: IP address of the destination network R: IP

The following command creates an I P standard Access table: access-list Access list number {permit | deny} source [source-mask] In this command: ◆ Access list number: determines which access table the entry belongs. It is a number ranging from 1 to 9. ◆ Permit | deny: indicates whether the entry permits or blocks information traffic from a specific address. ◆ Source: determine the source I P address. ◆