multiwii 328p

Note: The following processes are Pro Mini 328P on the other. 1 , upload the example on the first board Arduinoisp program, the board becomes the board A ;2 , waiting to burn bootloader Board becomes the board B ;3, BoardAthe pinPinTenConnecting the BoardBof theRST, and then the boardAthe pinPIN11, A, -connecting the board separatelyBof thePIN11, A,,to the BoardBpower on. 4 , Arduino IDE the Menu "Tools"-- > "Programmer"-- > " Arduino as ISP , in the

Cleanflight can used on Multirotor aircraft and fixed-wing aircraft, it supports a variety for shapes and motor counts, Not limited toQuadcopters, Hexacopters, Octocopters, tricopters and planes. Cleanflight is Open-source flight Controller software which is 32-bit version of the original 8-bit multiwii code.Cleanflight can be used in multi-rotor aircraft and fixed-wing aircraft, which supports a variety of shapes and motion counts, not limited tofour

correct. The first program Blink. ino: // 0. pin definition # define LED_PIN 13 // define the LED pin as data PIN 13 (DIG13) // 1. initialize void setup () {pinMode (LED_PIN, OUTPUT); // initialize DIG13 as OUTPUT} // 2. loop void loop () {digitalWrite (LED_PIN, HIGH); // DIG13 output HIGH-level delay (1000); // 1 second delay digitalWrite (LED_PIN, LOW ); // DIG13 output low-level delay (1000); // delay 1 second} (1) Open Blink with Arduino IDE. ino, compiled; (2) generated in the Directory d:

long as the pin is connected, it can be adapted. Connect the following pins with the DuPont line 22: Mosi,vcc,rst,sck,miso,gnd.Unfortunately, due to the Arduino IDE's "high-end Air international", it does not recognize this modified firmware of the "Chinese characteristics" usbasp download line, the conventional method can not be burned at all, display the error "could not find USB device" usbasp "" "Avrdude:stk500_getsync (): Not in sync:resp=0x00", unable to connect.3. DispelIn the final anal

as long as the pin is connected, it can be adapted. Connect the following pins with the DuPont line 22: Mosi,vcc,rst,sck,miso,gnd.Unfortunately, due to the Arduino IDE's "high-end Air international", it does not recognize this modified firmware of the "Chinese characteristics" usbasp download line, the conventional method can not be burned at all, display the error "could not find USB device" usbasp "" "Avrdude:stk500_getsync (): Not in sync:resp=0x00", unable to connect.3. DispelIn the final a

development tool chain for the simple program to run. Whether the Hello World program can run can verify that your compiling, development, and running environments are correct. The first program Blink. ino is as follows:/// 0. Pin Definition# Define LED_PIN 13 // define the LED pin as the data PIN 13 (DIG13) /// 1. InitializationVoid setup (){PinMode (LED_PIN, OUTPUT); // initialize DIG13 to OUTPUT} /// 2. LoopVoid loop (){DigitalWrite (LED_PIN, HIGH); // DIG13 outputs a HIGH levelDelay (1000);