A detailed illustration of the access to the Internet in the absence of a line

A lot of people although the computer has a wireless network card but only through the local wired connection to the Internet, this condition how also can make touch also Internet?

　　Tools/raw Materials

First of all, need a notebook or desktop to do host, also have wireless network card (wireless network card also do not have?) you give up all right, there is no line by no wireless card then listen to the song and see the movie.

Second, the computer can be connected to the Internet via a local connection.

Meet these two conditions, you can easily set up an environment for touch through the computer to the Internet.

　　Steps/Methods

1. See if the Control Panel--> network connection is as shown in the picture

2. Select the two connections at the same time

3. Click the right mouse button on either of the selected two connections--> select bridging

Bridge prompt appears

A network bridge appears

Automatic bridging process for Network Bridge

The status of the bridge after Network Bridge is completed

4. To this point, wireless and local IP address management by the Network Bridge Management, view the local connection properties will be less IP content.

Right-click the wireless network connection--> Select Properties

5. In the attribute click on the wireless network configuration--> Add

6. Click Add, enter in the pop-up page:

Network Name (SSID), any personalized name, as long as not with the current can be found in the wireless network name repeat can

Network authentication: Shared

Data encryption: WEP

Automatically provide me with this key before canceling the check out

Network key: Any 5-digit combination of the password (this is the password is waiting for the touch of the connection to enter the password)

Confirm network key: Repeat Enter password

This is a computer to computer (specific) network ... Front tick

Are you sure

7. Determines

The above steps fourth through seventh, can be set before the network bridge is irrelevant

8. Click the Network Bridge--> right key--> properties

9. Select Internet Protocol (TCP/IP)--> properties

10. Set the local IP

Click to use the following IP address

IP Address: 192.168.0.XXX (the definition of IP address here is based on the LAN IP section of the distribution, some may be 192.168.1.XXX, but also some 172.16.1.XXX, etc. are different, I am here just general circumstances, do not know their own intranet IP, Can be in the bridge before the local connection set to automatically obtain IP, and then click Start--> Run-->cmd--> input ipconfig/all to view their own IP, subnet mask, gateway, etc.

Subnet Mask: 255.255.255.0 (again, this is the case in general)

Gateway: 192.168.0.1 (again, this is the case in general)

dns:202.96.209.5 (You can check the DNS server addresses that are commonly used in each province). I'm from Shanghai.

Set up, OK

　　Touch-End Settings

1. Open WiFi and find itouch this available network connection

2. Point itouch This available connection right blue arrow into set--> point static

Enter it sequentially

IP address: 192.168.0.YYY (same as computer format, remain in the same network section)

Subnet Mask: 255.255.255.0 (consistent with computer settings)

Router: 192.168.0.XXX (is the computer set the local IP address, is the gateway, not the router address, because it is through the computer to share the Internet, so the gateway is the computer's IP address)

dns:202.96.209.5 (with computer settings)

3. Click itouch Available connection, enter password, connect into itouch this access point

4. Complete.

OK, at this point, you can use touch to surf the web, I hope to help you.

This tutorial is also suitable for use in LAN environments where the company does not have wireless conditions.