After installing ArcGIS 10, start arcscene. The page is blank.

After ArcGIS 10 desktop is installed recently, ArcMAP, arcglobe, and arccatalog can be displayed normally. However, when arcscene is started, it is thrilling and there is no tool bar on the interface, there is only one title "arcscene" alone, and then there is an arccatalog floating panel on the right side of the lonely floating, other places are white "floating cloud", nothing. What's going on? In this case, we experienced the following setbacks:

 

A: Open "my computer", enter % USERPROFILE %/Application Data/ESRI/topics top10.0/arcscene in the address bar, press enter, and find normal under this folder. delete the sxt file and restart arcscene.

I acted in a well-behaved manner, and the space was still blank.

B: Download the SP1 Patch of ArcGIS 10 desktop and restart arcscene after installation.

The result is: the white space remains unchanged.

C: Check related posts in ArcGIS Resource Center and find a case similar to ArcMap initialization failure. The above prompt says that it is necessary to ensure that the local open gl version is above 2.0 or above. Then I checked whether I met the requirements and found that I met the requirements to eliminate this problem.

D: reinstall ArcGIS 10. The reinstallation result is the same as the original one. arcscene cannot be started normally and the interface is still blank.

E: the final solution.

Open "my computer" and enter % USERPROFILE %/Application Data/ESRI in the address bar, except for the desktop 10 folder, Engine 10 folder, errorreports folder, fontenginev6 folder, and local cashes folder required by ArcGIS 10, there are many external folders such as ArcMAP, arccatalog, arcscene, and arcglobe. I suspect this is the residual folder of my previous version 9.3.

In the arcscene folder of % USERPROFILE %/Application Data/ESRI/desktop 10.0, find normal. the sxt file, and then use the normal arcscene 10 successfully installed on someone else's computer. replace your sxt file and restart arcscene.

 

 

PS: To sum up the cause of this problem, it may be that the initial arcscene file normal. sxt has a problem, and the startup is blank. The cause of the problem is still unknown.