Note that the following configuration file only applies to ZTE ZTE-T A356 devices, other models need to modify the PID and vid.
Download the driver attachment (g3ewalk-linux.tar.gz) and run the following command to decompress the file/Etc/Directory:
$ SudoTar-Zxvf g3ewalk-Linux.tar.gz-C/Etc/
Run the following command:
$ Mkdir~/G3ewalk
$ Tar -Zxvf g3ewalk-Linux.tar.gz-C ~/G3ewalk
Disable the LAN ethernet card before dialing:
$ SudoIfconfig eth0 down//Enable LAN Ethernet Card: sudo ifconfig eth0 up
Perform G3 dialing contact:
$ Sudo~/G3ewalk/G3
Echo prompt:
Write by ishagua@www.pc-pub.com
Loading new driver. Please wait for 10 seconds...
Modprobe usbserial vendor = 0x19d2 Product = 0x0079...
Dialing...
Pon 3G...
Wait 10 seconds to complete dialing...
After dialing, start your pleasant online trip.
The dial light turns green and becomes successful :)
Refer:
[1] http://www.pc-pub.com/article-721-1.html
[2] http://forum.ubuntu.org.cn/viewtopic.php? F = 116 & t = 307397 & START = 0