Create a virtual machine from vsphere client and install a Windows 2008 64-bit operating system and network configuration

environment: Notebooks, IBM M3 Server (4 LAN,16g Ram , RAID1 400g hard drive done )

1, imm Port login Open remote Control side configuration esxi address, disable ipv6 exsi address is from which Nic out, to be tested, guess from the first, late can also be in the client on vmkernel< Span style= "font-family: ' Microsoft Jas Black ', ' sans-serif ';" > port group configuration)

2, laptop computer installed vsphere Client(notebook operating system is best for the number of bits, will be prompted), connect the first NIC, Configuration and ESXi the same network segment;

3. Connect esxi host via client

4, Create a virtual machine, Create a centos7 and windows R2 8g memory, virtual 4 card, 150g After the HDD provisioning delay zero, the hard disk must leave a little space, because exsi system itself to use, in the distribution of each 200g error when provisioning immediately after HDD)

5, Install the operating system by mirroring

6, 2008 After the operating system is installed, the first virtual network card is configured to test the network segment, the second virtual network card is configured to monitor the network segment; the first virtual network card goes to the first real physical NIC vmnic0 esxi vmnic1 vswitch1 vswitch0, second block selection vmnet1< Span style= "font-family: ' Microsoft Jas Black ', ' sans-serif ';" The premise is that the physical machine's 1 and 2 The block Nic has been connected to the test network and the monitoring network segment respectively

7, found from the virtual machine can ping the external testing and monitoring of the machine, but the external can not ping the virtual machine, find data, shut down the firewall can

8, install centos7 Similar, ignore,

Note: Writing documents is all about helping to remember later

Create a virtual machine from vsphere client and install a Windows 2008 64-bit operating system and network configuration