Create a Wireless AP in win7 to connect two computers to the Internet-rency logs-Netease blog

Create a Wireless AP in win7 to connect two computers to the Internet-rency logs-Netease blog

Create a Wireless AP in win7 to connect two computers

1, first, enable the wireless network card on a laptop and create a point-to-point connection, ensure the connection between the two machines

2, Configure ip : Make sure that the ip addresses of the two machines to be connected belong to the same network segment (except for IPv6 )

3, Disable the firewall (ensure that the connection information is passed in and out,XPTo allow incoming connections from other computers in Computer Advanced properties)< Advanced Firewall Configuration >

4, enable the disabled Administrator Account (connection of the Administrator account by default)

5, shared file, set up advanced sharing is set on the aP machine to restrict the file read permission when a user connects to the AP (it is recommended to share the permission FC , NTFS permission restriction)

6, use Ping command to check the network communication status

7, If the communication fails, the default gateway is set AP Of IP Address

8, Note that the settings are complete. AP After a host is connected, it is disconnected and reconnected.   It is switched from the routing function to the client. At this time, a wireless node built by win7 is completed ...... Of course, it is best to install the Intel Wireless WiFi management software on our computer, so that we can create a Wireless WiFi through the WiFi management software and the software has the principle of DHCP address allocation, eliminating the disadvantages of manual IP Address allocation.