Detailed operation on the SAS card function of HP computer, hp

Detailed operation on the SAS card function of HP computer, hp

Detailed operation on the SAS card function of HP computers in IDC Management

I. Software Removal Protection

1) After the computer is turned on, wait for the access to the dashboard selection system interface;

2) Press F1 to go To the BIOS page of the SAS card;

3 ). switch the cursor to >>> System Restore Mode. The mode is: (not protected, every time, week, month, or). Select not protected. (If Step 4 is feasible, skip this step)

4 ). switch the cursor to> disk tool, select the boot disk of the system to be operated, select the protection mode, and select "not protected "; (If the protection mode is unavailable, perform Step 3)

5). Save and restart.

Ii. Enable Software Protection

1) Make sure that the underlying driver is installed;

2) after entering the system, select the upper-layer protection version based on the underlying driver version for installation;

3) install and restart;

4). Wait until you enter the dashboard selection system interface;

5) Press F1 to go To the BIOS page of the SAS card;

6) switch the cursor to> disk tool, select the boot disk of the system to be operated, select the protection mode, and select "Protect ";

7) switch the cursor to> System Restore Mode. The modes include: (not protected, every time, week, month, And). Select each Restore Mode.

Iii. Upper-layer software usage

> The upper-layer software is different from the upper-layer software <

Iv. installation and repair system

Remove the Software Protection first. If you do not know how to perform this operation, see "1 ". If it is a dual system, go to the system interface, select the system you want to replace, and then enter PE. After that, everything will be the same as the USB flash drive system of other computers. After the system is installed with patches and other software, re-install the protection. For details, refer to "2 ".