Specific setting method
Users connected by telephone lines(Prepare two short network cables)
Connect the telephone line (the finer line) to the line port of the Cat (the smaller one). The Cat splits a network cable into the WAN port of the router and finds a shorter one.
Network cable, one connection to the computer, one connection to the router interface No. 3, the wiring method is as follows:
Note: the normal working status of the router is SYS flashing, the WAN port is always on or flashing, and the port connecting to the computer in the 1/2/3/4 port is always on or flashing.
Users who directly access the network cable(Prepare two short network cables)
Connect the incoming network cable to the WAN port of the router, find a short network cable, connect to the computer, and connect to the vro3 3 Interface. The wiring method is shown below:
Note: the normal working status of the router is SYS flashing, the WAN port is always on or flashing, and the port connecting to the computer in the 1/2/3/4 port is always on or flashing.
Set the local connection IP address on the computer to"
Automatically obtain the IP address"
1. Right-click"
Network neighbors", Select"
Attribute":
2. Click"
Local connection", Select"
Attribute":
3. Double-click"
Internet Protocol (TCP/IP)":
4. Select"
Automatically obtain the IP address""
Automatically obtain the DNS server address", OK:
1. Enter:
192.168.0.1Press enter and enter the password on the jump page.
AdminClick"
OK"
2. Select"
ADSL dialing", Enter the bandwidth account and password,"
OKAs follows:
If the WAN port status shows"Connected", You can browse the web page and surf the Internet.
Tip: After you access the Internet through a vro normally, you do not need to click "broadband connection". You can directly access the Internet at startup. If other computers need to access the internet
Network, directly connect the computer to any idle interface of vro1234, refer to step 2 to change the local connection to automatically get the ip address, no need to configure the router.
