Note: The vro is not a model, so you must connect the vro to the model, as shown in the following figure.
Route A line from vro1 1 to the WAN port of vro2 2, find a short network cable, connect a computer, and connect any interfaces of vro 1/2/3/4.
As shown in the following figure:
Note: the normal working status of vro2 2 is SYS flashing, the WAN port is always on or flashing, and the port connecting to the computer in the ports 1/2/3/4/is always on or flashing.
Set the local connection IP address on the computer to"
Automatically obtain the IP address"
<Click this link to obtain the ip address automatically in Win7
1. Right-click"
Network neighbors", Select"
Attribute
2. Right-click"
Local connection", Select"
Attribute":
3. Double-click"
Internet Protocol (TCP/IP)":
4. Select"
Automatically obtain the IP address""
Automatically obtain the DNS server address", OK:
1. Enter:
192.168.0.1Press enter and enter the password on the jump page.
AdminClick"
OK"
<192.168.0.1 cannot be opened? Click this link
2. Click"
Advanced Settings"Or"
Advanced Settings"
3. Click"
WAN port settings", Select the mode as"
DHCP", OK
4. Click"
LAN port settings ,Use 192.168.8.1 to log on to the vro settings page.", Change the LAN port address to 192.168.8.1
If the WAN port status shows"
Connected", You can browse the web page and surf the Internet.
Tip: If other computers need to access the Internet, directly connect the computer to any idle interface of vro1234, and change the local connection to automatic
You can obtain the IP address without configuring the router.