A few days ago in the blog, said, has been looking for a LAN (no Internet) for Remote Desktop control software. Think that teamviewer out of the internet can not be Remote Desktop. Everyone Baidu, most of the players are also resolute reply "can not." ”。
Today, with colleagues, again tested, found that the original TeamViewer can be implemented in the LAN Remote Desktop. It 's OK. OK. OK.
First look at the measured interface, using the TeamViewer12 version
Did you see it? The green light is lit in the lower left corner, prompting you to connect over the LAN. Most people are in the red light at the time of operation and are prompted to check the network settings because there is no internet connection.
The solution is as follows:
See the "Other" option in the image below and click it. And then set it up.
Configure according to the following figure
In the general settings--Network settings--Incoming LAN connections--Select accept only. The red light turned into a green light immediately. The IP address of the computer being charged to the same network segment is now controlled remotely.
Dream to find her 1100 degrees, the original in a key room.
Original blog, forwarding please indicate the source.