We all know that Visio is a powerful tool for drawing flowcharts, but inserting latex may become blurred. below is what I think is the best clarity.
Step 1: Save the Visio diagram as a PDF, file --> page settings --> page size selection and adjustment to adapt to the drawing, and then click "easy", for example, prw.visio.pdf
Step 2:
* To insert data to a floating window, you can directly use
\ Begin {figure}
\ Centering
\ Includegraphics [width = \ textwidth?pr=visio= }\\
\ Caption {fit} \ label {}
\ End {figure}
* If you want to insert data to a non-floating area, you can use the following method. To use \ caption outside of figure, you can add it in the introduction section:
\ Makeatletter
\ Newcommand \ figcaption {\ def \ @ captype {figure} \ caption}
\ Newcommand \ tabcaption {\ def \ @ captype {table} \ caption}
\ Makeatother
Then, run the following command.
\ Begin {Center}
\ Includegraphics%width%4cm,height%8cm%%pr%visio%}
\ Figcaption {System ClusteringAlgorithmFlowchart} \ label {}
\ End {Center}