This article is mainly about recordingVirtual MachinesinstallationCentos, and the process of executing commands in Windows using Xshell for yourself and the people you need to learn and use. The difficulty lies primarily in the setup of Windows and CentOS networks, enabling window to connect to CentOS and execute shell commands
The software used in this article is as follows: 1, VMware WorkStation 12 (Installation process slightly) Http://rj.baidu.com/soft/detail/13808.html?ald 2, Centos 6.5/HTTP// Www.centoscn.com/CentosSoft/iso/2013/1205/2196.html 3, Xshell 5(Installation process slightly)Http://rj.baidu.com/soft/detail/15201.html?ald
I. VMware installation of virtual machinesVirtual machine configuration
ii. Configuring Windows7 and CentOS NetworksReference: http://jingyan.baidu.com/article/90808022dc25a1fd91c80fa5.html 1, set Windows network parameters 1.1 right-click Properties
1.2 Set the IP address to get automatically
1.3 Windows7 in the start serviceVMware DHCP ServiceVMware NAT Service
2. Set Virtual machine 2.1 Set Virtual Machine network adapter to NAT
2.2 Setting up the Virtual network editor
3. Set the CentOS network parameter 3.1 confirm the network is connected status
3.2 Open the CentOS terminal
3.3 Execute command in Terminal view CentOS IP address ctrl+t open terminal and execute command:ifconfig eth0
Iii. using Xshell to connect to the CentOS Execution shell command1. Configure connection Properties
2. Execute shell command, successful connection
Iv. References1, http://jingyan.baidu.com/article/e75aca85bbef20142fdac655.html 2, http://jingyan.baidu.com/article/ 90808022dc25a1fd91c80fa5.html 3, http://jingyan.baidu.com/article/f7ff0bfc1e2a322e26bb13d5.html 4,/HTTP// Www.cnblogs.com/lhj588/archive/2012/02/15/2353139.html
Linux_windows7 using Vmare to install Centos6.5 and use Xshell to connect to CentOS