Master deal with Kingston U disk is not recognized with a trick

Kingston u Disk Double-click cannot open the general situation is caused by a logical error, often occurring after an accidental power outage.

The solution is relatively simple, with software to restore the U disk's Guide data so that the system can be normal access to the.

The following simple introduction of a powerful U disk operating software software. The same applies to solid-state drives.

Download Diskgenius rebuild the partition table, and follow these steps. Open the direct interface after the program, note that you must make sure that the U disk has been recognized in my computer. If the disk is not shown in the system is another case.

In the case of recognition of the hard drive, the following is the way to select "Search for lost Partitions (Rebuild partition table)" After selecting the disk character of U disk.

After rebuilding the partition table, select rebuild the master boot record. Some of the advanced point of the U disk has hidden partitions, if not restored also can not be used.

Then safely uninstall the hard drive, and then plug in the computer should be able to identify the normal.

If the failure is recommended to use the last method, the first format, the data on the hard disk to restore processing, relative time and the size of the hard disk directly proportional. The relevant data recovery software usage can look at the link below.

Before restoring the data, check the health of the hard drive first.

Right-click the hard drive letter and select "Bad track detection and repair".

The following interface appears, and you can still select a different letter. The lower-left corner has "start detection" and "try to repair."

The following figure is in the detection process

Detection will appear after the report, I have seen is not bad, if prompted a bad way then again select "Try to repair" can be.