PS Simple to make beautiful neon text special effects tutorial

This tutorial teaches PS text effect learners to use PS simple to make beautiful neon text effect method, the difficulty of the general tutorial, produced by the text effect is quite beautiful. Recommended and network management of the family to share the study of friends! First, let's look at the final effect chart:

Grade has been not to go, decided to send a post to save experience. This is a beginner's tutorial, a tutorial for novice drivers.

The specific production steps are as follows:

1,CRTL+N Create a new canvas, size 1920*1080

2, execute: Filter---Render--clouds. If you think the effect is not ideal, you can ctrl+f more than a few times.

3, the foreground tones into: #15aec4 background tones into: 000000 new layer, radial gradient, from the center outward pull. (personal mapping prefers to pull a reference line)

4, change the layer blending mode to multiply the bottom, ctrl+j duplicate one layer, change the layer blending mode to overlay, then ctrl+j duplicate one layer.

5,ctrl + SHIFT + ALT + E to stamp a layer.

6, add a mask to the stamped layer, paint a few strokes with a brush at 3 2, and add the middle fresh color.

7, the front color change back to White (#ffffff), playing on their favorite words, size set themselves, ctrl+j copy a layer.

8, the 2 text layers are raster, double-click the above text layer, open the layer style: gradient overlay, angle 0, gradient settings such as figure,

The colors of the gradient are: 0e87c0, E3d3d3, fff006, F0AA02, f41323, F227e1, 22f345

9, perform the filter-blur-Gaussian Blur--18px. Then hold down CTRL and click on another text layer, get the selection, and then select-Modify-Shrink, enter 2. Add a layer to the top and fill it with white.

10, start in the reflection, a new group, bar these 3 text layers are pulled in. Then copy the group. Then edit--transform--vertical inversion. Move to a suitable location. Change the opacity to 34, add a mask, and pull a linear gradient.

11, create a new blank layer, select the Brush tool, open the brush preset, select the brush shown in the picture, change the size to around 10px, select the Pen tool,

Draw a one-day path between two words, right button, stroke path, check simulation pressure, confirm. Then right-click again to delete the path.

12,ctrl+j copy a layer, then filter-blur-Gaussian Blur--8px, end.

Add a layer of smoke layer, or the stage that light layer, the effect should be good, but I personally like simplicity, so good.

The end of the tutorial, the above is the PS simple to make beautiful neon text special effects tutorials, I hope you like!

Category:

• PS Text Tutorial