Skyeye@ubunutu8.04 x86 installation, Skyeye network attention

Http://forum.ubuntu.org.cn/viewtopic.php? F = 97 & t = 130148 & START = 0 & St = 0 & Sk = T & SD =

I am a newbie, according to the guidance of the excellent arts, install Skyeye to run, but the network is dead, helpless, take the latest version 1.25 to install, successful ~

Note:

1. The Skyeye network requires the Tun module, lsmod | grep Tun:
Code: Tun 12672 0

Here, after the Skyeye network is started, it is 1.

2. To enable the tap virtual Nic for Skyeye, start it with sudo:

Sudo Skyeye-e Linux

3. After starting Skyeye, ifconfig should be able to see the tap0 Nic. The IP address is specified in Skyeye. conf. The network is disconnected.

4. After Skyeye is started, ifconfig should be able to see eth0 IP 10.0.0.2. Ping 10.0.0.1 indicates that your computer should respond.

5. Ping the outside to ping the inside!


The installation procedure is as follows:

1. Go to http://gro.clinux.org/projects/skyeye/download skyeye-1.2.5and skyeye-testsuite-1.2.5

2. Extract

3. Install Skyeye:./configure; Make; sudo make install;

4. testsuite no installation, enter the skyeye-testsuite-1.2.5/uClinux/at91/uclinux_cs8900a

5. sudo Skyeye-e Linux


There are several Nic failures or running errors in the configuration directory. Start with this.


Supplement: skyeye0.9.2 in testsuite of skyeye1.2, which can be used by sudo ~

Last edited by steeven on
, Edited once in total

To allow virtual machines to access the Internet:
Host:
Sudo ip addr del 192.168.2.3 Dev eth0
Sudo brctl addbr br0
Sudo brctl addif br0 eth0
Sudo brctl addif br0 tap0
Sudo ifconfig br0 tap0 up
Sudo route add default GW 192.168.2.1
On the VM:
Ifconfig eth0 192.168.2.4
Route add default GW 192.168.2.1

Note that 192.168.2.3 is the original IP address of eth0, and 192.168.2.4 is the new IP address on the virtual machine. It does not need 10.0.0.2, which is equivalent to surfing the Internet with the company IP address.