localhost for ipv6

PV6 is considered an alternative to the traditional 32-bit address space on the ipv4--Internet, which is used to solve the problem of the impending exhaustion of the existing IPV4 address space. However, since a large number of hosts and devices are

A summary of methods to disable IPV6 under Linux--http://www.jb51.net/linuxjishu/335724.htmlThis article mainly introduces the method of disabling IPv6 in Linux, the operation of disabling IPV6 or considering the current and IPV4 compatibility

IPV6 is considered an alternative to IPv4, which is used to address the impending exhaustion of existing IPv4 address spaces.But for now, opening IPv6 may cause some problems. So sometimes we need to close IPv6.Here's how the IPv6 shutdown method

Today, a strange problem has occurred, the localhost access is not found 404, but there are 127.0.0.1 to access. The reason was finally found because Windows resolved localhost to IPv6 address: 1 instead of 127.0.0.1. Check the hosts to IPv6 has

How to disable IPv6 in CentOS 7 Recently, a friend of mine asked me how to disable IPv6. After searching, I found the following solution. The following describes how to disable IPv6 on my CentOS 7 mini server. You can do this in two ways.Method

In Linux, the method of enabling and disabling IPv6 is now supported by IPv6 by default. However, for some application servers that do not support IPv6 well, enabling IPv6 affects the server's network performance. after all, the current network

IPv6 has not been fully popularized yet, but IPv6 is effective after the system is installed, which affects network performance to a certain extent. Therefore, we recommend that you disable IPv6. Now we will describe how to disable it in the

Redhat 5 disables IPv6 and redhat5 disables ipv6Redhat 5 Disable IPv6 IPv6 has not been fully popularized yet, but IPv6 is effective after the system is installed, which affects network performance to a certain extent. Therefore, we recommend that

Recently, a friend of mine asked me how to disable IPv6. After searching for a few, I found the following scenario. Here's how to turn off IPv6 on my CentOS 7 mini-server.You can do this in two ways.Method 1Edit File /etc/sysctl.conf, VI

Start from Windows VistaIPv6 is enabled by default.In the environment where both IPv4 and IPv6 coexist, IPv6 has a high priority. Therefore, the obtained IP address is in the IPv6 format. Fortunately, to solve this problem, you do not have to