CCNA lab review 1, clock and Encapsulation

Clock Configuration

650) this. width = 650; "src =" http://www.bkjia.com/uploads/allimg/131227/0454301F6-0.png "title =" 1.png"/>

1. Configure vroa A (assuming vroa A is the DCE end of the serial line)

Router> en

Router # conf t

Router (config) # host Router

Routeconfig # int s0/0

Routeconfig-if # ipad 192.168.1.1255.255.255.0

Roupid (config-if) # clock rate 64000

Routeconfig-if # noshutdown

Roupid (config-if) # exit

2. Configure vrob B (assuming vrob B is the DTE end of the serial line)

Router (config) # host RouterB

RouterB (config) # int s0/0

RouterB (config-if) # ipad 192.168.1.22.16255.255.0

RouterB (config-if) # nosh

RouterB (config-if) # exit

View the Routing Encapsulation Protocol command show interface)

Modify encapsulation: encapsulation hdlc, ppp)

650) this. width = 650; "src =" http://www.bkjia.com/uploads/allimg/131227/0454304Z7-1.png "title =" 1.png"/>

This article is from the "beyond and beyond" blog, please be sure to keep this source http://franksyl.blog.51cto.com/3207517/1293612