How to Use ghost on SATA hard drive

Many friends have previously asked if the SATA hard drive can use ghost. When using ghost to back up the system, they may have encountered this situation,
After the system is started with a floppy disk or a CD, the system is black after the ghost. EXE command is used. Does ghost not support SATA devices?
Can't we back up the system after using a SATA hard disk? The answer is: the SATA hard disk can also be used for cloning, but the operation is
I need some tips.
First, let's analyze why the system crashes normally. Generally, i865pe (beiqiao) is used to support SATA hard drive boards)
+ The chipset of ich5r (nanqiao). However, due to the limitations of the ich5r nanqiao chip, one of the IDE channels is used in Win9x, WINNT, and dossystems.
This is why the system stops responding after ghost is started because ghost cannot determine whether the group of ides is available in the system.
After knowing the cause, we can take the right medicine. Generally, 865 of the motherboard BIOS provides an option to block a group of IDE channels, so that the system is still
Recognize two groups of IDE channels.
The p4p800 motherboard is used as an example to describe the operation method in detail: (the following methods are the disc Startup Mode)
1,
One SATA hard disk is mounted on the sata1 interface, and one CDROM is mounted on the primary ide interface (set as the primary disk ):
A)
Start the system and enter BIOS settings. Select ide configuration from the main menu.
B) Change the onboard ide operate
Change Mode to compatible mode.
C) in [enhanced mode support on], select [primary
P-ATA + S-ATA]
D) After restarting the bios, you will find that there are only four ide devices in the main menu. [primary ide
Master] is [CDROM],
[Primary ide slave] is [none], and [secondary ide master] is [ide
Disk] (your hard disk model ),
[[Secondary ide slave] is [none]
E)
After the DOS is started with a CD, run ghost.
2. One SATA hard disk is mounted on the sata1 interface, and one CDROM is mounted on secondary.
IDE interface:
Just change the [primary P-ATA + S-ATA] in step 3 above to [secondary
P-ATA + S-ATA], you can, at this point the system will
The sata1 and sata2 devices are treated as [primary ide master] and [primary ide
Slave].
3,
If you use a Sata-supported motherboard, but do not use a SATA device, some BIOS still enable the SATA channel by default,
At this time, the use of ghost to back up the system will also lead to a black screen, so we also need to set it in the BIOS to block the SATA channel,
In the third step of the first case
Change P-ATA + S-ATA to [P-ATA ports
Only]. In this case, the system will block the SATA device,
You can use it as a general motherboard without a SATA device.
The above is a summary of some small experiences when I use SATA devices and ghost, and I hope it will be useful to you.
The same is true for the motherboard of the other model, but the options in it are not enriched by Asus.