silent hard drive enclosure

processing hard drive LED does not light, indicating that the problem may be in the mobile hard disk itself. Careful observation of the hard disk USB interface and interface cable, no abnormal pin, open the hard disk box, the surface parts of the body also no discoloration

What are the computer hardware maintenance skills? In short, the function of computer hardware is to input and store programs and data, and to process data into available forms. From the outward appearance, the microcomputer is composed of the host box and the external equipment. The devices in the host enclosure are connected to the host through an interface and a connecting line. Then, the computer hard

The removable hard drive is not detected on more than one computer and the hard drive LEDs are not lit. The hard drive has no light on it, which means there is a problem with the mobile

For users with a demand for performance, upgrading an existing hard drive to a fixed hard drive is the most effective method. The upgrade method is the same as upgrading the mechanical hard drive. However, if the "solid-st

protected] robin]# Megacli-pdlist-aall# # #有如下样式的几段, which shows the actual number of hard drives (below is a piece of 500G SSD information)Enclosure Device id:32Slot Number:3Drive ' s postion:diskgroup:0, Span:1, arm:1Enclosure position:0Device Id:3wwn:50025388a0061518Sequence Number:2Media Error count:0Other Error count:0Predictive Failure count:0Last predictive Failure Event Seq number:0PD Type:sataRaw

I bought a 1 TB hard drive. because I want to switch with WINDOWS, I can only use the NTFS format. If you install hal and supervisor, you will not talk about it. I. install the software # emergentfs-3g 2. configure and compile the kernel # cd/usr/src/linux # makemenuconfig check Filesystems --- MFilesysteminUserspacesupport # ma I bought a 1 TB hard

installation is successful, the following can be used to achieve the NTFS partition read and write the NTFS-3G. Step 2: Configure and mount a mobile hard drive in NTFS format 1. obtain the NTFS partition information first.Sudo fdisk-l | grep NTFS [Root @ DB-Server klb] # sudo fdisk-l | grep NTFS/Dev/sdc1*1 244 1955776 + 7 HPFS/NTFS2. set the mount point and run the following command to mountMount-t NTFS-3

The hard drive is formatted to reload the system, can the previous files be recovered? This morning found that the computer a bit of a problem, has been prompted me signs of poisoning, but antivirus software has been prompted me no problem, do not know whether the virus is too novel, or free antivirus software is not easy to use. After a hint, the computer is quiet down, there is no fault, with my use bega