20171207 European floor -to-ceiling windows |
|
In fact, if there is a CAD diagram, do not need to do so, just draw the rectangle and then squeeze out the line |
1: floor-to-ceiling window box |
1: Draw a plane, 2750,4500, segment for the |
|
|
2: Convert to editable poly |
|
|
3: Select the left and right lines, connect, enter: 2,65 |
|
|
4: Select the two lines that you just created, connect: 2,80 |
|
|
5: Select the middle face, Extrude -200mm |
|
|
6: Draw a "rectangle" spline along the middle of the box |
|
|
7: Import the spline of the window, stroke with "line" |
|
|
8: Click on the rectangle, compound object-"loft |
|
|
9: Convert lofted shapes to editable polygons |
|
|
10: Select "Boundary", above the top view, select All, and then pull out about 200mm distance, in fact, is to match the hole in the window |
|
|
11: Then adjust the graphic in the front view, just select "point" and move the point position to place it right in the window. |
|
|
12: Move this part slightly out of the way, it will have three-dimensional |
|
2: part of the window of a floor-to-ceiling window |
1: Draw a plane along the middle, segment the |
|
|
2: Convert to editable poly |
|
|
3: Select left and right side, then connect, 2,-80 |
|
|
4: Move this side slightly upwards |
|
|
5: Check Four horizontal lines, connect, 3,0 |
|
|
6: Select the three lines, click "Chamfer", enter 35 |
|
|
7: Select the side of the middle bar, extrude 40mm |
|
|
8: Then select the other eight faces and separate them out |
|
|
9: Select the vertical side, click Connect, 2,-68 |
|
|
10: Select the sideways side, click Connect, 2,-68 |
|
|
11: Then select these Small Faces, extrude the -40mm |
|
|
12: Separate out |
|
|
|
|
20171207 Chinese windows |
1: Draw a plane 2750,3000 |
|
|
2: Convert to editable poly |
|
|
3: Select the left and right side, connect 2,0 |
|
|
4: Move two lines, respectively, of high 1000mm,2460mm |
|
|
5: Check this two line, connect 2,46 |
|
|
6: Select the middle face, insert 60 |
|
|
7: Frame Extrusion 20mm |
|
|
8: Place the middle face, Extrude -200mm |
|
|
9: Convert the middle face to editable poly |
|
|
10: Select the upper and lower faces, connect, enter 1,0 |
|
|
11: Select the left side, Extrude 40mm |
|
|