Hong Zhi Education-effect map-European floor-to-ceiling windows and Chinese windows

20171207 European floor -to-ceiling windows		In fact, if there is a CAD diagram, do not need to do so, just draw the rectangle and then squeeze out the line
1: floor-to-ceiling window box	1: Draw a plane, 2750,4500, segment for the
	2: Convert to editable poly
	3: Select the left and right lines, connect, enter: 2,65
	4: Select the two lines that you just created, connect: 2,80
	5: Select the middle face, Extrude -200mm
	6: Draw a "rectangle" spline along the middle of the box
	7: Import the spline of the window, stroke with "line"
	8: Click on the rectangle, compound object-"loft
	9: Convert lofted shapes to editable polygons
	10: Select "Boundary", above the top view, select All, and then pull out about 200mm distance, in fact, is to match the hole in the window
	11: Then adjust the graphic in the front view, just select "point" and move the point position to place it right in the window.
	12: Move this part slightly out of the way, it will have three-dimensional
2: part of the window of a floor-to-ceiling window	1: Draw a plane along the middle, segment the
	2: Convert to editable poly
	3: Select left and right side, then connect, 2,-80
	4: Move this side slightly upwards
	5: Check Four horizontal lines, connect, 3,0
	6: Select the three lines, click "Chamfer", enter 35
	7: Select the side of the middle bar, extrude 40mm
	8: Then select the other eight faces and separate them out
	9: Select the vertical side, click Connect, 2,-68
	10: Select the sideways side, click Connect, 2,-68
	11: Then select these Small Faces, extrude the -40mm
	12: Separate out
20171207 Chinese windows	1: Draw a plane 2750,3000
	2: Convert to editable poly
	3: Select the left and right side, connect 2,0
	4: Move two lines, respectively, of high 1000mm,2460mm
	5: Check this two line, connect 2,46
	6: Select the middle face, insert 60
	7: Frame Extrusion 20mm
	8: Place the middle face, Extrude -200mm
	9: Convert the middle face to editable poly
	10: Select the upper and lower faces, connect, enter 1,0
	11: Select the left side, Extrude 40mm